Documentation/4.10/Modules/CurvatureAnisotropicDiffusion
Introduction and Acknowledgements
This work is part of the National Alliance for Medical Image Computing (NAMIC), funded by the National Institutes of Health through the NIH Roadmap for Medical Research, Grant U54 EB005149. Information on NAMIC can be obtained from the NAMIC website.  

Module Description
Performs anisotropic diffusion on an image using a modified curvature diffusion equation (MCDE).
MCDE does not exhibit the edge enhancing properties of classic anisotropic diffusion, which can under certain conditions undergo a 'negative' diffusion, which enhances the contrast of edges. Equations of the form of MCDE always undergo positive diffusion, with the conductance term only varying the strength of that diffusion.
Qualitatively, MCDE compares well with other nonlinear diffusion techniques. It is less sensitive to contrast than classic PeronaMalik style diffusion, and preserves finer detailed structures in images. There is a potential speed tradeoff for using this function in place of Gradient Anisotropic Diffusion. Each iteration of the solution takes roughly twice as long. Fewer iterations, however, may be required to reach an acceptable solution.
Use Cases
Most frequently used for these scenarios:
 Use Case 1:
Tutorials
N/A
Panels and their use
Parameters:
 Anisotropic Diffusion Parameters: Parameters for the anisotropic diffusion algorithm
 Conductance (conductance): Conductance controls the sensitivity of the conductance term. As a general rule, the lower the value, the more strongly the filter preserves edges. A high value will cause diffusion (smoothing) across edges. Note that the number of iterations controls how much smoothing is done within regions bounded by edges.
 Iterations (numberOfIterations): The more iterations, the more smoothing. Each iteration takes the same amount of time. If it takes 10 seconds for one iteration, then it will take 100 seconds for 10 iterations. Note that the conductance controls how much each iteration smooths across edges.
 Time Step (timeStep): The time step depends on the dimensionality of the image. In Slicer the images are 3D and the default (.0625) time step will provide a stable solution.
 IO: Input/output parameters
 Input Volume (inputVolume): Input volume to be filtered
 Output Volume (outputVolume): Output filtered
List of parameters generated transforming this XML file using this XSL file. To update the URL of the XML file, edit this page.
Similar Modules
N/A
References
N/A
Information for Developers
Section under construction. 