Slicer:Slicer2.7Ubuntu

From Slicer Wiki
Revision as of 18:52, 15 May 2008 by Marianna (talk | contribs) (1 revision)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search
Home < Slicer:Slicer2.7Ubuntu

Slicer 2.7 on Ubuntu

Notes for installing Slicer 2.7 on Ubuntu:

  • Slicer requires csh, which isn't installed by default on some Ubuntu distributions. It can be found in Synaptic (Berkeley version).

If you are having problems with OpenGL:

To verify your OpenGL installation is working, run the command

glxgears

To install an NVIDIA graphics driver that supports OpenGL:

sudo apt-get install nvidia-glx nvidia-kernel-common
sudo nvidia-glx-config enable

Edit the /etc/X11/xorg.conf file to change 'nv' to 'nvidia' in this section:

Section "Device"
         Identifier      "NVIDIA Corporation NV41 [Quadro FX 3450/4000 SDI]"
         Driver          "nvidia"
         BusID           "PCI:5:0:0"
EndSection

To install an ATI graphics driver that supports OpenGL:

sudo apt-get update
sudo apt-get install linux-restricted-modules-$(uname -r)
sudo apt-get install xorg-driver-fglrx
sudo depmod -a
sudo aticonfig --initial
sudo aticonfig --overlay-type=Xv