Documentation/Nightly/Modules/PercutaneousPathDesigner

From Slicer Wiki
Revision as of 06:23, 25 July 2014 by Ayamada (talk | contribs)
Jump to: navigation, search
Home < Documentation < Nightly < Modules < PercutaneousPathDesigner


For the latest Slicer documentation, visit the read-the-docs.


Introduction and Acknowledgements

This work is supported by NA-MIC, NCIGT, and the Slicer Community.

Author: Atsushi Yamada, Shiga University of Medical Science (SUMS), Japan
Contributors: Junichi Tokuda (Brigham and Women's Hospital), Koichiro Murakami (SUMS), Shigeyuki Naka (SUMS), Tohru Tani (SUMS)
Contact: Atsushi Yamada, <email>ayamada@belle.shiga-med.ac.jp</email>

Shiga University of Medical Science, Japan  
NA-MIC  
NCIGT  

Module Description

PercutaneousPathDesigner1.png

Use Cases

N/A

Tutorials

N/A

Panels and their use

PercutaneousPathDesigner Parameters panel
PercutaneousPathDesigner Outcomes panel
PercutaneousPathDesigner Configurations panel
  • Parameters panel
    • Target Point requires MarkupsFiducial List created in Markups Module which has only one markup.
    • Output Fiducial List requires MarkupsFiducial List created in Markups Module which has no markups.
    • Skin Model requires a model which represents a skin, that is, a surface on the needle tips.
      • Opacity Slider can change the opacity parameter of the Skin Model selected.
    • Obstacle Model requires a model which represents obstacles needle paths should avoid.
      • Opacity Slider can change the opacity parameter for the Obstacle Model selected.
    • Path Analysis Start button starts creating path candidates from target point to the skin model to avoid the obstacle model.
  • Outcomes panel
    • All Paths (Yellow) check button displays all path candidates shown as the yellow bundles of lines.
      • Opacity Slider can change the opacity parameter for the yellow bundles.
    • The Longest Path (Green) check button displays the longest path as the green line.
    • The Shortest Path (Blue) check button displays the shortest path as the blue line.
    • The Path Candidate (Red) check button displays the one of the yellow bundles as the red line.
      • Path Candidate (No.) Slider can select the line from the yellow bundles.
      • Point Candidate on the Path Slider can extend and shrink the selected red line from the skin entry point.
      • Point on the Path button writes the target and the tip position Markups to the Output Fiducial List you set in the Parameters panel.


Similar Modules

N/A

References

Percutaneous Approach Analysis project in 2014 Winter Project Week

Information for Developers