For the stable Slicer documentation, visit the 4.10 page.
Introduction and Acknowledgements
Creates a BSpline transform from a displacement field defined at scattered points by using the Multi-level BSpline interpolation algorithm.
1. Create a B-Spline transform based on two sets of fiducials.
2. Create a B-Spline transform based on two sets of points read from files. These files can contain the initial and deform configurations for a biomechanics-based FEM or mesh-free registration. The resulting B-Spline transform can be used to warp 3D images, a process which is very time consuming if spatial interpolation is performed using the mesh . This module reduces the image warping time from hours to seconds.
Panels and their use
- Initial landmarks: Ordered list of fiducials in initial position. Select these from the moving image if the resulting transform is used for image registration.
- Displaced landmarks: Ordered list of fiducials in displaced position. Select these from the fixed image if the resulting transform is used for image registration. Input files:
- File with initial point positions: File with coordinates of points in initial position.
- File with displaced point positions: File with coordinates of points in displaced position.
- Ignore first value: Ignores first value in each line of the input files (which may be a node number). Output transform:
- Slicer BSpline Transform: Slicer transform node for the generated B-Spline transform. NOTE: Only 3D transforms are handled by 3D Slicer! Advanced parameters:
- BSpline Transform file: File where to save the transform. Needed for 1D and 2D transforms, as Slicer does not create a transform node for these transforms.
- Space dimension: The space dimension (1D, 2D or 3D).
- For use in: Where is the transform going to be used? If the transform is a 3D transform to be used in Slicer, a coordinate transformation (similar to what Slicer does internally) is applied to the coordinates before the transform is computed.(only 3D transforms can be used in Slicer)
- Invert transform: Inverts the transform. Always done if transform is for use in Slicer.
- Use linear approximation: Sets the initial B-Spline grid values using a linear approximation of the displacements.
- B-Spline Grid Spacing: The distance between the BSpline control grid points.
- Domain computed from input points: Computes the transform domain as the bounding box of the input points.
- Minimum domain coordinates: The minimum coordinates of the domain (if not computed from input points).
- Maximum domain coordinates: The maximum coordinates of the domain (if not computed from input points).
- Tolerance: Absolute tolerance in approximating the transform at the input points.
- Minimum grid spacing: Minimum grid spacing during grid refinement.
- Maximum number of levels: Maximum number of levels of B-Spline refinements. Output information:
- Residual: Display residual approximation error on successful completion.
1. Joldes GR, Wittek A, Warfield SK, Miller K (2012) "Performing Brain Image Warping Using the Deformation Field Predicted by a Biomechanical Model." In: Nielsen PMF, Miller K, Wittek A, editors. Computational Biomechanics for Medicine: Deformation and Flow: Springer New York. pp. 89-96.