Documentation/4.6/Modules/PlmDICOMRTImport

From Slicer Wiki
Jump to: navigation, search
Home < Documentation < 4.6 < Modules < PlmDICOMRTImport


For the latest Slicer documentation, visit the read-the-docs.



Introduction and Acknowledgements

Extension: Plastimatch
Acknowledgments:

  • An Ira J Spiro translational research grant (2009)
  • NIH / NCI 6-PO1 CA 21239
  • The Federal share of program income earned by MGH on C06CA059267
  • Progetto Rocca Foundation – A collaboration between MIT and Politecnico di Milano
  • The National Alliance for Medical Image Computing (NAMIC), funded by the National Institutes of Health through the NIH Roadmap for Medical Research, Grant 2-U54-EB005149; information on the National Centers for Biomedical Computing can be obtained from http://nihroadmap.nih.gov/bioinformatics
  • NSF ERC Innovation Award EEC-0946463


Webpage: www.plastimatch.org
Author: Greg Sharp (Department of Radiation Oncology, Massachusetts General Hospital)
Contributor1: Julien Finet (Kitware)
Contact: Greg Sharp, <email>gcsharp@partners.org</email>

Kitware, Inc.  
National Alliance for Medical Image Computing (NA-MIC)  

Module Description

This is the DICOM / DICOM-RT import module. It allows you to select a directory containing DICOM-RT structure sets and/or dose, which it will convert into 3D Slicer labelmap and/or scalar image. This module also loads the DICOM CT image without requiring the need to use the Slicer volume import wizard.

Note: In a Slicer, a labelmap voxel can only belong to one structure. However, DICOM-RT allows a region to belong to any number of strucutres. Therefore, importing DICOM-RT structure sets as Slicer labelmaps will usually result in a loss of data. This module uses a "last structure wins" strategy for assigning labels to overlapping volumes.

Note: Because DICOM-RT structures are specified as polylines, there is a small loss of fidelity when they are converted into rasterized volumes.

Use Cases

Before Registration
After Registration


Tutorials


Panels and their use

  • Input/Output panel:
    • Input DICOM directory: Here you choose any file in the directory which contains the DICOM-RT data.
    • Reference Volume (to set size): This is an optional field. But if your dicom directory does not contain a CT, it is required. Here you choose any loaded volume. The import module will create a labelmap at the same resolution and pixel spacing as the reference volume that you choose here.
    • Output Image: Here you choose where to put the output CT image. Unless you want to replace an existing volume, you should choose "Create New Volume".
    • Output Labelmap: Here you choose where to put the output DICOM-RT structure set labelmap. Unless you want to replace an existing volume, you should choose "Create New Volume".
    • Output Dose Image: Here you choose where to put the output DICOM-RT dose image. Unless you want to replace an existing volume, you should choose "Create New Volume".
User Interface


Similar Modules

References

  • G Sharp et al. "Plastimatch - An open source software suite for radiotherapy image processing," Proceedings of the XVIth International Conference on the use of Computers in Radiotherapy, May, 2010.

Information for Developers